Experimental Investigation on Concrete by Partial Replacement of Marble Powder and Bore Well Sand
- Marble powder,
- Bore well sand,
- water cement ratio,
- compressive strength,
- tensile strength test
Copyright (c) 2019 International Research Journal of Multidisciplinary Technovation
This work is licensed under a Creative Commons Attribution 4.0 International License.
Concrete is the most widely used construction material in civil engineering industry because of its high structural strength and stability. Leaving the waste materials to the environment directly can cause environmental problem. Marble stone industry generates both solid waste and stone slurry. The concrete industry is constantly looking for supplementary material with the objective of reducing the solid waste disposal problem. In this paper cement is replace by marble powder the research is carried out by using M25 grade concrete with replacement of 5%, 10%, 15% marble powder by cement in addition of 50% replacement of normal sand by bore well sand and is carried out to determine the optimum percentage of replacement at which maximum compressive Strength, split tensile strength, flexural strength is achieved.
2. Al-Amoudi OSB, Maslehuddin M and Abiola TO (2004) Effect of type and dosage of silica fume on plastic shrinkage in concrete exposed to hot weather. Construction Building Material. 18, 737-743.
3. Bharatkumar BH, Narayan R, Raghuprasad BK and Ramachandramurthy DS (2001) Mix proportioning of high performance concrete. Cement Concrete Composites. 23, 71–80.
4. Ahmed N. Bdour et.al (2011) Utilization of Waste Marble Powder in Cement Industry he feasibility of using Waste Marble Powder (WMP) in cement industry as a substitute limestone. http://www.eco- web.com/edi/111216.html
5. Omar M. Omar et.al (2012) Influence of lime stone waste as partial replacement material for sand and marble powder in concrete properties. HBRC Journal, PP 193-203
6. IS 383 -1970 “Specifications for Coarse and Fine Aggregates from Natural Sources for Concrete”, Bureau of Indian Standards, New Delhi.
7. IS 10262 -1981 “IS Method of Mix Design”, Bureau of Indian Standards,
8. New Delhi
9. IS 516 -1959 “Methods of Tests for strength of concrete”, Bureau of Indian Standards, New Delhi
10. IS 456 -2000 “Code of Practice for Plain and Reinforced Concrete”, Bureau of Indian Standards, New Delhi.