Experimental Study on Behaviour of Clutch Plate Lining using Jute Fibre
Clutch plates are usually made of cast iron and high carbon steels. The cast iron has high compressive strength, low tensile strength and low ductility. Clutch lining material is made up of asbestos. In order to obtain good life and more effectiveness and to reduce the cost of clutch plate, the new fibre reinforcement with clutch material is introduced. For the reinforcement with clutch liner material, jute fibre is selected. Due to the reinforcement of the clutch material, the properties has been improved. Then, the comparison of the properties and effectiveness of the new plate with the existing plate is to be done.
Ku H, Wang H, Pattarachaiyakoop N, Trada M, “A review on the tensile properties of natural fiber reinforced polymer composites” in Composites Part B: Engineering, 2011 42, pp 856-873.
Kabir MM, Wang H, Lau KT, Cardona F, “Chemical treatments on plant based natural fibre reinforced polymer composites: An overview” in Composites Part B: Engineering, 2012 43, pp 2883-2892.
Pujari S, Ramakrishna A, & Suresh Kumar M, “Comparison of Jute and Banana Fiber Composites: A Review” in International Journal of Current Engineering and Technology, 2014 pp 121-126.
Ajith Gopinath, Senthil Kumar.M, Elayaperumal A, “Experimental Investigations on Mechanical Properties Of Jute Fiber Reinforced Composites with Polyester and Epoxy Resin Matrices: A Review” in Procedia Engineering, 2014 pp 97 2052 – 2063.
Karmaker, A C, Hoffmann A, Hinrichsen G, “Influence of water uptake on the Mechanical Properties of jute fiber-reinforced polypropylene” in Journal Applied Polymer Science, 1994 volume 54, pp1803-1807.
Gassan, J. and Bledzki, A, “Effect of cyclic moisture absorption desorption on the Mechanical properties of silanized jute-epoxy composites” in Polymer Composites 20: pp 604-611.
Copyright (c) 2019 International Research Journal of Automotive Technology
This work is licensed under a Creative Commons Attribution 4.0 International License.